Search

The Online Encyclopedia and Dictionary

 
     
 

Encyclopedia

Dictionary

Quotes

   
 

Atmospheric reentry

(Redirected from Re-entry)

Atmospheric entry is the transition from the vacuum of space to the atmosphere of any planet or other celestial body. The term is not used for landing on bodies which have no atmosphere e.g. the Moon.

Atmospheric reentry refers to the return to an atmosphere previously left for space. Often the word "atmospheric" is dropped and the term reentry (or re-entry) is taken to mean atmospheric reentry in context.

Contents

Advantage of atmosphere

Compared with landing on a planet without atmosphere, atmospheric entry has the advantage that no rocket is needed for deceleration. This gives a considerable reduction of the total delta-v needed for a spaceflight from the Earth, with return with soft landing, such as in the case of a manned spaceflight. Without this saving such a spaceflight would cost a delta-v of twice the 9.7 km/s for launch, is 19.4 km/s, which may even be impossible with current technology.

From a Low Earth Orbit a deorbit burn is needed, but this costs a delta-v of only ca. 80 m/s, depending on the altitude. From elsewhere a transfer orbit can be chosen that directly enters the atmosphere.

Objectives

For a manned spacecraft and for objects of value the requirements are:

  • decelerations in the atmosphere are gentle enough
  • the landing is soft
  • not too much heat is developed.
  • the landing does not cause damage on the surface and is in international waters or in a suitable country, with recovery vehicles ready.

For expendable objects, preventing damage at Earth's surface is the objective. This is accomplished by either burning up or evaporating the object in the atmosphere, or by bringing it down on deserted land or water. For example, even if the Hubble Space Telescope would no longer be needed, it would still be needed to carry out a mission to attach a de-orbit rocket, for either controlled reentry or moving it to a higher orbit.

Suborbital flights

Because a major difference between sub-orbital and orbital spaceflights is the greater speed of the latter, atmospheric reentry poses much more of a technical challenge with orbital flights than with suborbital flights. This article will focus on orbital reentry, though the same considerations apply with sub-orbital flights, only to a lesser extent. Also note that the below only really applies to flights where the vehicle needs to return to Earth intact. If the vehicle is, say, a satellite that is ultimately expendable, then there naturally is no need to worry about deceleration and non-destructive reentry.

Deceleration and aerobraking

The main challenge with reentry is deceleration from high orbital speeds. To avoid our orbital spacecraft performing a meteor-style "landing", it has to slow down. An obvious way of slowing down is through atmospheric friction and drag (ie. using wind resistance) . This is called aerobraking. Atmospheric friction however can rapidly generate a destructive amount of heat. Many smaller meteoroids burn up through such friction and never reach the Earth's surface. So is there a better way?

Why superfast reentry isn't an option

For our orbital spacecraft, one might consider minimizing the "exposure time" by passing through the atmosphere faster. However, going faster would again mean more friction, reaching deeper and denser layers of the atmosphere at higher speeds (yet more friction) and thus more temperature (and at best result in the meteor-style landing we wanted to avoid). The kinetic energy of the spacecraft has to be dissipated. It can only be dissipated by conversion to heat. Quicker conversion means higher temperatures. The enemy is high temperature and therefore it is a slower passing through the atmosphere which is required - not a faster one.

The key to successful reentry

The key challenge with successful reentry then is to brake as much as possible while still in higher atmospheric layers and avoid plunging downwards too quickly.

Why active braking cannot be solely relied upon

Of course, some active braking is required in order to enter the atmosphere, until then no atmospheric drag is available. In theory, it would be imaginable to accomplish all or practically all the deceleration by active, powered braking, by firing the craft's rocket engine in the opposite direction. This however would require a large amount of fuel, this fuel would have had to be lifted into orbit in the first place and therefore the size of the orbiting space craft relative to the launch vehicle would have to be much smaller, unless the spacecraft were refuelled in orbit.

Aerobraking currently the only option

Thus, the only currently known and feasible way of decelerating from orbital speeds is mainly through aerobraking.

Reliance on heat shields

Conventional wisdom dictates that aerobraking is best achieved through orienting the returning space craft to fly at a high drag attitude coupled with ultra strong heat shields on the spacecraft, to convert the craft's high kinetic energy into thermal energy (heat) by atmospheric friction. This unavoidably rapid conversion of a large amount of kinetic energy to heat results in extremely high temperatures, so the heat shield needs to be extremely strong and reliable. Relying mainly on the heat shield (and possibly a high drag attitude) makes reentry a critical time. Any errors in this portion of the flight profile are difficult to recover from and will probably have serious impact upon the mission. Death and/or mission failures have occurred during re-entry. Nevertheless, the use of strong heat shields has so far been regarded as the only practical approach and all orbital returning spacecraft have been equipped with such.

Blunt body heat shields

These four shadowgraph images represent early re-entry vehicle concepts. A shadowgraph is a process that makes visible the disturbances that occur in a fluid flow at high velocity, in which light passing through a flowing fluid is refracted by the density gradients in the fluid resulting in bright and dark areas on a screen placed behind the fluid.H. Julian Allen pioneered and developed the Blunt Body Theory which made possible the heat shield designs that were embodied in the Mercury, Gemini and Apollo space capsules, enabling astronauts to survive the fiery re-entry into Earth's atmosphere. A blunt body produces a shockwave in front of the vehicle--visible in the photo--that actually shields the vehicle from excessive heating. As a result, blunt body vehicles can stay cooler than pointy, low drag vehicles.

Feathered reentry

However, maverick aircraft designer Burt Rutan has recently (as of 2004) demonstrated the feasibility of an alternative or complementary approach to atmospheric reentry with the suborbital SpaceShipOne:

SpaceShipOne has what has been described as a pair of flipping wings; the spacecraft itself changes shape for reentry.

This increases drag, as the craft is now less streamlined. This results in more atmospheric gas particles hitting the spacecraft at higher altitudes than otherwise. The aircraft thus slows down more in higher atmospheric layers (which is the very key to efficient reentry, see above). It should also be noted that SpaceShipOne, in its "wings flipped" configuration, will automatically orient itself to a high drag attitude. Rutan has compared this to a falling shuttlecock.

Related info

The highest speed reentry so far was achieved by the Jupiter atmosphere probe aboard the Galileo spacecraft, which reached 170,700 km per hour and a temperature of 14,000 °C.

Notable reentry mishaps occurred during the following missions:

  • Vostok 1 - service module failed to detach for 10 minutes, but the crew survived
  • Voskhod 2 - service module failed to detach for some time, but the crew survived
  • Soyuz 5 - service module failed to detach, but crew survived
  • Soyuz 11 - crew perished due to early depressurization
  • Space Shuttle Columbia disaster - damaged heat shield led to spacecraft breakup at high altitude, crew perished
  • Genesis - parachute failed to deploy, unmanned capsule crashed into desert floor, contents damaged but some science data recoverable


Uncontrolled reentry

More than 100 metric tons of man-made objects reenter in an uncontrolled fashion each year. The vast majority burn up before reaching earth's surface. On average, about one cataloged object reenters per day. Approximately, one-fourth of all objects are of U.S. origin.

See also

Last updated: 05-13-2005 07:56:04